| Story Views | |
| Now: | |
| Last Hour: | |
| Last 24 Hours: | |
| Total: | |
A little bit of woodwork
Things have slacked off on the work and financial front. Documents have all been signed, funds transferred and nothing mission critical is going to happen for the next month (I hope). So there’s not much for me to do and frankly I’m tired of listening to the mess Trudeau and all the other Liberal (Hah!) politicians are making with their virtue signalling (instead of doing the more mundane but important stuff like not spending so much) and trying to tell everyone else what they can and cannot think, the dickheads. So I’ve decided to immerse myself in a little woodwork.
There’s something soothing about natural wood and I’ve always had a penchant for a little DIY since getting my Grade 1 in woodwork at school. Something about patiently working with the grain and texture that fully engages the hands and mind, focusing the attention on minutia, driving out all the negative shit that silts up the daily consciousness. The gentle rhythmic motion of hand sanding, staining and finishing soothes the head, smoothing over all your own roughened edges and allowing a little time to put all your mental dominoes in the right order, letting the right bits of your mental jigsaw fall into their correct places and lower the blood pressure. It’s an exercise that is worth all the pills and potions in the world, and probably much better for you.
Anyway, the project I’ve begun is the improvement of a cabinet we bought two years ago. The main body of which is solid pine, which looks great, but like so much Canadian furniture the back is thin, tatty and unfinished. The current back is some very rough looking plywood which doesn’t even cover the whole back, and since we’re using the unit as a room divider, this needs ‘tidying up’. So the current back, which is frankly a bit of a bodge job (See picture), has to go.
What I’m doing is very simple. I’m removing the old and rough 3/16ths plywood and rather shabby looking beading, and replacing it with a double layer of 1/4 inch finished plywood into a rebate already cut into the pine. Which will make for a more solid back with a nicer finish, even if it does make the whole unit about ten kilos heavier. When I’m done we won’t be looking at a cheap and tatty bit of rough plywood back which needs covering with a backcloth, but a simple solid and plain looking piece of nicely finished wood grain in keeping with the antique knotty pine front and sides. Nothing fancy, although I might be tempted to add some light 1/8th inch pine beading around the edges at a later date. It all depends on the end result. So long as it looks neat and tidy when I’m done.
So far the inner layer has been cut, sanded and stained and I’m waiting for the varnish to dry before removing the ugly old (and much more fragile) cabinet backing to pin and glue the inner layer in place. Then I’m going to sand the outer piece to a fine finish on the edges, sand, stain, varnish and fix with panel pins and glue. Like I say, this is nothing complicated, just a gentle exercise in improving on a previous bodge job.
While I’m at it, I’m also fitting a small LED light internally to illuminate my single malts and the wine rack. So we’ll have a much more functional piece of kit than before. Not bothering with a motion sensor, just a simple bar light and switch.
Doing stuff like this, at least for me, helps clear the mind and improve decision making. Which is nice. More on this project later.
Source: https://billsticker.wordpress.com/2017/02/20/a-little-bit-of-woodwork/
