Online:
Visits:
Stories:
Profile image
By SurvivalBlog (Reporter)
Contributor profile | More stories
Story Views

Now:
Last Hour:
Last 24 Hours:
Total:

Letter Re: Sharp-Shoot-R Products

Monday, September 22, 2014 21:45
% of readers think this story is Fact. Add your two cents.

(Before It's News)

I was truly amazed by the work Scott put into cleaning his firearms! I shoot a fair amount of hard cast lead bullets for plinking and target shooting but keep velocities under 1600 fps, and above that I use jacketed bullets, which seems to simplify my cleaning. One patch lightly gun oiled up and down the barrel three times, then I follow that with a dry patch up and down the barrel three times. Take a lightly oiled scrap of cloth and wipe down the outside of the firearm, then the bolt face and moving parts. If the firearm is of the semi-auto variety, I add a drop to each slide rail, work it in with a finger tip, and cycle the slide a couple of times. Every third cleaning I remove the slide, bbl, gas piston, et cetera and do a more extensive cleaning and oiling, leaving a light film of oil on moving parts. If the fire arm is to be stored two or three years, I make the second patch lightly oiled also. Revolver cylinders get the same treatment as the bore. For years I used kerosene with a little motor oil added to change the color of the mix. Then I tried Army Surplus light gun oil, then Hoppies Gun oil, and now I use Remington gun oil. They all seemed to work well, as long as I didn’t store my firearm in a leaky trailer or in a home with a working swamp cooler. Semi-auto carry pistols require periodic cleaning and shooting to obtain reliability. Learn yours, and stick to it. Your life depends on it. AM

Scot Replies: Thanks so much for the email! We all come up with our own strategies for gun care, and what works for one person may not work for another. I usually do pretty much what you do, when I get home from the range, which is run a patch or two wet with Cleaner-Lubricant-Protectant through the bore and wipe down the exterior with CLP. If the mechanism is dirty enough that I think function might be impaired, I will clean and lube it before putting it away. That said, I am leaving stuff in the barrel and as the layers build up, it gets harder and harder to get the bore completely clean. That’s what has happened to more than one of my guns, and it meant much more work to get them clean when I finally decided to do it.

Oils don’t do a good job of removing copper or lead. CLP products are better but are not as efficient as special purpose cleaners.

Ed’s Red, the cleaner I make at home, is pretty close to what you are using by mixing kerosene and motor oil. Here is the formula for Ed’s:

  • 1 part Dexron II, IIe or III Automatic Transmission Fluid – GM Spec D20265 or later
  • 1 part K1 Kerosene
  • 1 part Aliphatic Mineral (same thing as the odorless mineral spirits from the home store)
  • 1 part Acetone (CAS#67-64-1)

You can also add lanolin, to make it a better protectant.

Source: http://survivalblog.com/letter-re-sharp-shoot-r-products/

Report abuse

Comments

Your Comments
Question   Razz  Sad   Evil  Exclaim  Smile  Redface  Biggrin  Surprised  Eek   Confused   Cool  LOL   Mad   Twisted  Rolleyes   Wink  Idea  Arrow  Neutral  Cry   Mr. Green

Top Stories
Recent Stories

Register

Newsletter

Email this story
Email this story

If you really want to ban this commenter, please write down the reason:

If you really want to disable all recommended stories, click on OK button. After that, you will be redirect to your options page.