| Story Views | |
| Now: | |
| Last Hour: | |
| Last 24 Hours: | |
| Total: | |
Five Favorite Handgun Powders
By Bob Shell
USA –-(Ammoland.com)- Like long guns, there are a wide variety of suitable handgun powders. Also like rifle powders, in order to be one of my favorites it has to have been around for a long time and stand a good chance of being in production years from now. It should have some versatility and in fact a couple have some use in rifles. I have loaded everything from a 25 auto to a 500 S & W, so there is a lot of differences in the propellants that I use. It is frustrating to have developed some good loads with a certain powder and then the powder is gone. Yes, you can usually buy it somewhere years later but at some point it will dry up or become much more expensive. It is also true that a good replacement load can be developed with another powder but I was disappointed when Alcan 7 was dropped as it was one of my favorites at the time.
In the 1970’s I was doing a little match shooting with a 38 special and a couple types of cast bullets. I was using two propellants at the time Bullseye and WW 230, both of which I liked. Winchester dropped 230 and went to 231 which is an improved version of the 230. I tried it in the 38 and have been using it ever since. Among other rounds I use it in is the 25 auto and the 380 and 9 mm Luger. Many other similar size rounds have been used with 231 with success. Like any propellant it might not be the best in all of the applications I use it in but it works well enough to produce good ammo. With a light bullet, it is one of my favorites in the 45 ACP.
I can’t imagine any loading bench operating without the next powder which is Unique. It has been around since the late 1890’s and is still one of the all-time favorite powders in use today. That is no accident. It can be used in almost any handgun round, although it is not the best for everything. It used to be somewhat dirty burning but it has been cleaned up in the last few years. It is flexible almost beyond belief, especially in the type of work I do. It is a good powder for cast bullets in rifles and makes a good blank powder for rifles. For handguns, it would be slow for really small rounds though it would work in a pinch and of course in large rounds would not be ideal for high velocity ammo. For moderate loads, using cast bullets in a 41, 44, and 45 Colt it would be hard to beat. It is a relatively low density flake powder and easy to ignite both desirable traits. It may very well be the most flexible powder currently being produced. If I am making some general purpose cast bullet ammo in a 41, 44, or 45 Colt I always grab Unique. The amount depends on the bullet weight and what velocity level I want it to be. I always buy it in 8 LB. kegs.
Another fine old timer is 2400. It has been around for many years and with good reason. While not suitable for small rounds, with rounds from the 357 on up it really shows its merits, especially with heavier bullets. It is at its best with full powder loads as it can produce good velocities and reasonable pressures. In a 357 using jacketed bullets from 140 grains on up performance is impressive. I have a friend I load for using 2400 and a 158 grain jacketed flat nose and he harvests a lot of deer using his Ruger Blackhawk. For 41, 44 mag and 45 Colt heavy loads it is one of the best performers available. With light loads it tends to burn dirty, so that is where Unique would come in. For some obsolete rifles, it works well and in a 351 WSL with a 180 grain it is the best.
The next powder is meant for magnum cartridges using heavy bullets. There are several good powders for that use such as AA-1680, H-110 and 4227 and IMR 4427. In addition, WW 296 would have to rate up there. They are all similar and as long as they are used as designed, they will do well. Such rounds as the 454 Casull, 460 and 500 S & W and any other similar rounds do well with these propellants. In a 41 or 44 magnum with heavy bullets, they are also good. They are not real flexible as smaller rounds and reduced loads should not be attempted with these propellants. I have seen reduced loads using 296 fail to push the bullet out of the barrel, which can cause a dangerous situation. Most of the reloading manuals warn against using less than the minimum listed and I strongly suggest that you follow that. In fact, while safe the minimal loads are usually inconsistent. If you observe a large muzzle flash during day time shooting chances are pretty good that the load is too light. I lump these powders together because of their similarities and the fact that they are at their best in a large handgun with full loads. In a Circuit Judge rifle, I use 296 with a 300-grain hollow base bullet to good effect.
Flexibility is something that I consider very important. That is one reason that I like the 30-06 so much is its flexibility. The same holds true with powder choices. There are many good propellants available but some may work in a narrow range of calibers. I use some of those powders but they would not be in my favorite five. If I shot one specific caliber that took a narrow range powder to perform best then it may rank among my favorite five. My last choice took some thought because of the type of work I do. With that thought, I went with AA 5744. For smaller caliber handguns it won’t do well but the heavyweights it is fine. With a 500 S & W it is a great performer. It has an advantage of being able to be loaded down and still work. Therefore, to a point in a 460 or 500 you can reduce the load and still get decent results. Another use that I really like is its ability to work well in old black powder rifles producing safe loads. In a 12.17 X 44 with a 300-grain bullet it is my favorite load. Even when under loaded it still works though some unburned granules are visible.
Choosing five is not easy. I use a lot of Unique but if for some reason I can’t get it then I go to Herco as it is very similar and works well. There are times I use either Red or Green Dot, as they are a bit faster and may work better in some small rounds. In a 357, 41, and 44 mag using light bullets at high speeds then I will grab some Blue Dot. I have used a lot of Bullseye and for really small rounds and blanks it is hard to beat. If you load a broad spectrum of rounds it is a good idea to have a second or even a third choice in case your favorite powder is unavailable. In the last year or so it has been all too common to have your favorite not available.
That illustrates the importance of keeping good records. That way you can keep track of all your loading info, both good and bad. Keep a record of your bad loads so they won’t be repeated in the future. With the panic buying that goes on much of that stuff is grabbed off the shelf even if the buyer doesn’t have the ability to use it. How many basements and garages have too much unnecessary ammo and supplies which will eventually go bad if not used? More often than not they end up selling it because they need the money for something else. Real or imagined many folks will go on a buying binge if there is a threat to their gun rights. I would suggest that if more people voted wiser in the first place then we would not have to worry about that.
About Bob Shell:
A Custom Reloader of Obsolete and Antique Ammo, Bob Shell, writes about the subject of Guns, Ammo, Shooting and Related Subjects. For more information, visit: www.bobshellsblog.blogspot.com.
This post Five Favorite Handgun Powders appeared first on AmmoLand.com Shooting Sports News .
Source: http://www.ammoland.com/2016/07/five-favorite-handgun-powders/
